From a walk around your site to alerts in your inbox
Two things happen in parallel: we get the cameras right, and we connect the AI layer that reads what they see. Here is the whole process.
Cameras & recorder
Your IP cameras record to an NVR on your own network, as they always have.
Frames analysed
Frames go to the detection models within the budgets we set per camera and per hour.
Events & clips
Detections become a searchable timeline, each with a short clip around the moment.
Alerts
Events that match your rules email the right people, with the frame attached.
What working with us looks like
1 · Site assessment
We walk the site with you: what has gone wrong before, what you need to see, where power and cable can run, and what your hours are. You get a camera plan, not a product list.
2 · Install & commission
Mounting, cabling, the recorder, the network and remote access. We aim cameras for the job they have to do, then test each one at the hour it matters, including at night.
3 · Connect the AI layer
We connect the analysis to your recorder, set zones and tripwires, choose your after-hours window and alert recipients, and tune the budgets per camera.
4 · Tune & support
The first fortnight is tuning: too many alerts, not enough, a zone in the wrong place. Then ongoing health checks, storage and firmware, and callouts when you need them.
A timeline instead of a haystack
The dashboard answers the question you actually have: what happened at the dock between four and six? Instead of scrubbing, you read the events and open the clip.
- Live view with detection boxes while you are watching.
- Event timeline you can search by camera, label and time.
- Clips captured around each event, roughly ten seconds either side.
- Counts and reports for people and vehicles, per camera, over time.